Cisco IE 3010 Switch Getting Started Guide
12
Cisco IE 3010 Switch Getting Started Guide
78-19582-02
• Relative humidity around the switch does not exceed 95 percent
(noncondensing).
• Altitude at the installation site is not higher than 10,000 feet.
• For 10/100 and 10/100/1000 fixed ports, cable lengths from the switch to
connected devices are not longer than 328 feet (100 meters).
• For cable lengths for small form-factor pluggable (SFP)-module connections,
see the hardware installation guide on Cisco.com and the module
documentation.
Installation Warning Statements
This section includes the basic installation warning statements. Translations of
these warning statements appear in the Regulatory Compliance and Safety
Information for the Cisco IE 3010 Switch document that is on the documentation
CD.
Warning
This unit is intended for installation in restricted access areas. A restricted
access area can be accessed only through the use of a special tool, lock and
key, or other means of security.
Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment.
Statement 1030
Warning
To prevent the system from overheating, do not operate it in an area that
exceeds the maximum recommended ambient temperature of:
140°F (60°C)
Statement 1047
Warning
This equipment is intended to be grounded to comply with emission and
immunity requirements. Ensure that the switch functional ground lug is
connected to earth ground during normal use.
Statement 1064
To Next Page
Loading...
Need help?
General