Cisco ISA 3000 Hardware Installation Guide

3-35
Cisco ISA 3000 Industrial Security Appliance Hardware Installation Guide
Chapter 3 Connecting the ISA 3000
Connecting to DC Power
Figure 3-2 mini-USB Cover
Step 3
Connect the mini-USB side of a cable to the USB Console port on the Cisco ISA 3000.
Step 4 Connect the opposite end of the mini-USB cable to the USB port on your PC.
Step 5 If your PC warns you that you do not have the proper drivers to communicate with the router, you can
obtain them from your computers manufacturer, or go here:
https://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
Step 6 Start up a console terminal.
Step 7 See the initial configuration section for more details.
Connecting to DC Power
Warning This product relies on the building’s installation for short-circuit (overcurrent) protection.
Ensure that the protective device is rated not greater than 60 VDC minimum, 5A maximum.
Statement 1005
Warning Installation of the equipment must comply with local and national electrical codes. Statement
1074

Cisco ISA 3000 Specifications

General

Brand	Cisco
Model	ISA 3000
Category	Security System
Language	English