6
Chapter 3: Getting to Know the Wireless-B Ethernet Bridge
The Back Panel
Wireless-B Ethernet Bridge
Chapter 3: Getting to Know the Wireless-B Ethernet Bridge
The Back Panel
All connections to the Bridge are made through the ports in its back panel, shown in Figure 3-1.
Reset The Reset button resets the Bridge to its factory default settings.
X-II The X-II (MDI/MDI-X) slide switch offers a choice between two settings. Use the X setting if you
are connecting the Bridge to a network adapter. Use the II setting if you are connecting the
Bridge to a hub or switch.
LAN The LAN port is where you will connect the Ethernet network cable.
Power The Power port is where you will connect the power adapter.
Important: Resetting the Wireless-B Ethernet
Bridge will erase all of your settings (WEP
encryption, wireless settings, etc.) and replace
them with the factory defaults. Do not reset the
Wireless-B Ethernet Bridge if you want to retain
these settings.
Figure 3-1: Back Panel
To Next Page
Loading...
Need help?
General
