Cisco MX Series User Manual

The Touch controller Settings
menu
To open the Settings menu, tap the system or user name in the
upper left corner and tap Settings.
System configuration
To enter the Administrator Settings menu, tap Administrator,
enter Username and Passphrase, and log in. A soft keyboard
appears when you tap the input fields. Tap Admin Settings.
The Administrator Settings menu is protected with the system
passphrase.
Read how to configure your system with a Touch controller
go to page 25.
You can set restrictions to users’ access to the settings
menu. This can be done on the web interface. Go to Setup
> Configuration > User Interface and set User Preferences to
Off. With this restriction, only System Information, Call Status,
Diagnostics and Restart are available for the users.
You can find a complete description of the Touch controller
menus in the user guide for your video conference system.
Not all settings are available on all products; therefore the menu
items shown to the right may or may not be present on your
system.
Settings
System Information
Camera Control
Ringtone & Sound
Administrator
Call Status
Diagnostics
Language
Restart
Display
The Settings menu
• Ringtone & Sound: Select a ring tone, the ring tone volume and key tone.
• Camera Control: Set the whitebalance, exposure and backlight compensation.
• Main Source Selection: Select the main input source, e.g. camera control.
• Display: Select brightness, whitebalance and DVI mode for the main video display.
• Language: Select the language for the user interface.
• System Information: An overview of the system configurations.
• Call Status: An overview of the call parameters when in call, e.g. protocols,
transmit and receive rates, packet loss.
• Diagnostics: Set additional system logging on.
• Restart: Restart the system.
• Administrator: See below.
The Administrator Settings menu
• Tracking: Choose tracking speed and set up snap-to-whiteboard feature
when you have a SpeakerTrack 60 camera.
• Date, Time & Location: Configure date and time settings.
• Call Details: Configure the default call rate and auto answer settings.
• Provisioning: Start the provisioning wizard.
• Pairing: See information about the endpoint the Touch is paired to, and
unpair from that endpoint.
• IP & VLAN: Configure the IP and VLAN settings. If the Touch controller
is connected via LAN, there are separate entries for the codec and the
Touch.
• Network Status - Codec: Current network status for the codec.
• Network Status - Touch: Current network status for the Touch controller.
• SIP: Configure the SIP settings.
• H323: Configure the H.323 settings.
• Security: See which certificates are installed on your system.
• EMC Resilience: Change the Touch controller's resilience to electromag-
netic noise.
• Reset: Complete a factory reset. This resets all of your settings. You
cannot undo a factory reset.
Main Source Selection
Administrator Setti
EMC Resilience
Reset
Call Details
Back
Pairing
IP & VLAN
Provisioning
SIP
H323
Date, Time & Location
Network Status
Tracking
Security
Cisco TelePresence Video Systems
D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016. Copyright © 2016 Cisco Systems, Inc. All rights reserved. 11
Getting Started Guide
Introduction
User interfaces
Web interface
On-screen setup assistant
Appendices

Touch
User interfaces

Cisco MX Series Specifications

General

Brand	Cisco
Model	MX Series
Category	Conference System
Language	English