Configuring the Cisco SPA8800 IP Telephony Gateway in an Asterisk Environment
© 2009 Cisco Systems, Inc. All rights reserved. Page 20 of 69
4. Repeat for Line 3.
5. Click Submit All Changes.
6. The entire configuration process is complete once the SPA8800 has rebooted.
Testing the Phone System
Test the phone system as follows for appropriate behavior:
1. Test internal calls:
a. Verify that analog phones can call each other internally. For example
call from 101 to 102.
b. Optional: Verify that analog phones can call IP phones internally. For
example, call from 101 to 200 [if configured]
2. Test inbound calls:
a. From the PSTN, call a phone line attached to the SPA8800's FXO line.
Verify that the appropriate phone rings, analog phone 101 in this
document's example.
b. From the PSTN, call a DID associated with the Asterisk server.
Verify that the appropriate phone rings, analog phone 101 in this
document's example.
3. Test outbound calls:
a. From an analog phone, make an outbound call using the PSTN by using
the appropriate steering digit, 8 in this document's example.
b. From an analog phone, make another simultaneous outbound call using
the PSTN by using the appropriate steering digit, 8 in this document's
example. Verify that both calls succeed, using both configured outbound
PSTN lines.
c. From an analog phone, make an outbound call using the ITSP by using
the appropriate steering digit, 9 in this document's example.
To Next Page
Loading...
Need help?
General