10
24-Port 10/100/100 Gigabit Switch
Chapter 3: Installation
Hardware Installation
To connect network devices to the Switch, follow these instructions:
Make sure all the devices you will connect to the Switch are powered
off.
Connect a Category 5 Ethernet network cable to one of the
numbered ports on the Switch.
NOTE: Use Category 5e Ethernet network cables for your
Gigabit connections.
Connect the other end to a PC or other network device.
Repeat steps 2 and 3 to connect additional devices.
If you are using a miniGBIC port, then connect a miniGBIC module
to the miniGBIC port. For detailed instructions, refer to the module’s
documentation.
NOTE: The miniGBIC ports are shared. Do not use port 12 if
you are using the miniGBIC1 port. Do not use port 24 if you are
using the miniGBIC2 port.
Connect the supplied power cord to the Switch’s power port, and
plug the other end into an electrical outlet. When connecting power,
always use a surge protector.
Power on the devices connected to the Switch. Each active port’s
corresponding LED will light up on the Switch.
Hardware installation is complete.
1.
2.
3.
4.
5.
6.
7.
To Next Page
Loading...
Need help?
General
