9
Cisco TelePresence IX5000 and IX5200 First-Time Setup
OL-27038-01
Powering on the System and Enabling the Cisco TelePresence Administration Software GUI
Figure 2 Bootup Screen
c. Watch the main display screen as the system is booting.
Step 2 Note the IP address that displays on the top right of the screen as shown in Figure 2. If your system has
already booted, tap the top left of the Touch 10 controller, then tap Info, and note the system IP address.
You use that information to sign in to the Cisco TelePresence System Administration. This IP address
displays until you sign in to Cisco TelePresence System Administration or use Secure Shell (SSH) to
sign in to the IX5000.
Note If the IP address that displays is 192.168.100.2, the system could not contact the DHCP server or your
system does not use DHCP. If your network does not use DHCP, set a static IP address for your system
as described in the “Configuring an IX5000 or IX5200 System With a Static Network Address” section
on page 10.
Step 3 If you have not already done so, configure the Cisco Unified Communications Manager GUI. For
detailed instructions to configure Cisco Unified Communications Manager, refer to the Configuring
Cisco Unified Communications Manager for the IX System document.
Step 4 Open a browser on a computer that is connected to your network.
Step 5 In the URL field, type the IP address that you obtained in Step 2 and press Enter. The browser launches
Cisco TelePresence System Administration.
Tip If you did not make a note of the IP address and it no longer appears on the display, tap the number that
displays on the top left corner of the Touch 10 controller, then tap System Info.
To Next Page
Loading...
Need help?
General
