For Cisco Unified Communications Manager 4.3 and earlier:
•
cmterm-7914-sccp.5-0-4.exe
•
For Cisco Unified Communications Manager 5.0(1), 5.0(2), and 5.0(3):
cmterm-7914-sccp.5-0-4.cop
•
For Cisco Unified Communications Manager 5.0(4) and later:
cmterm-7914-sccp.5-0-4.cop.sgn
Step 9
If you added the firmware file to the cart, click the Download Cart link when you are ready to download the
file.
Step 10
Click the + next to the firmware file name in the Download Cart section to access additional information about
this file. The hyperlink for the readme file is in the Additional Information section, which contains installation
instructions for the corresponding firmware:
cmterm-7914-sccp.5-0-4.readme.html
Cisco Unified IP Phone Expansion Modules 7915 and 7916 installation
This section describes how to install Cisco Unified IP Phone Expansion Modules 7915 and 7916.
Cisco Unified IP Phone Expansion Modules 7915 and 7916 firmware issues
Before you use the Cisco Unified IP Phone Expansion Module 7916, you must load the expansion module
with firmware release B016-1-0-4-2 before using the phone to support relevant features on your expansion
module.
Before you use the Cisco Unified IP Phone Expansion Module 7915, you must load the expansion module
with firmware release B015-1-0-4-2 before using the phone to support relevant features on your expansion
module.
The Cisco Unified IP Phones 7962G, 7965G, and 7975G support the Cisco Unified IP Phone Expansion
Modules 7915 and 7916. You can add a maximum of two expansion modules to these phones.
Install Cisco Unified IP Phone Expansion Modules 7915 and 7916 firmware
To download and install the firmware, perform these steps:
Cisco Unified IP Phone 7900 Series Release Notes for Firmware Release 9.3(1)SR2
9
Cisco Unified IP Phone 7900 Series Release Notes for Firmware Release 9.3(1)SR2
Cisco Unified IP Phone Expansion Module firmware installation
To Next Page
Loading...
Need help?
General