Introduction
These release notes support the Cisco Unified IP Phones 7900 Series running SCCP and SIP Firmware Release
9.3(1)SR2.
The following table lists the Cisco Unified Communications Manager release and protocol compatibility for
the Cisco Unified IP Phones.
Table 1: Cisco Unified IP Phones, Cisco Unified Communications Manager, and firmware release compatibility
Cisco Unified Communications ManagerProtocolCisco Unified IP Phone
Cisco Unified Communications Manager
Release 6.0 and later
Cisco Unified CallManager Release 5.1, 5.0,
4.3, 4.2, 4.1, 4.0
Cisco CallManager Release 3.3
SCCPCisco Unified IP Phones 7906G, 7911G, 7941G,
7941G-GE, 7961G, 7961G-GE, 7970G, and
7971G-GE
Cisco Unified Communications Manager
Release 6.0 and later
Cisco Unified CallManager Release 5.1 and
5.0
SIPCisco Unified IP Phones 7906G, 7911G, 7941G,
7941G-GE, 7961G, 7961G-GE, 7970G, and
7971G-GE
Cisco Unified Communications Manager
Release 6.0, 6.1, 7.0 and later
SCCPCisco Unified IP Phone 7931G
Cisco Unified Communications Manager
Release 7.0 and later
SIPCisco Unified IP Phone 7931G
Cisco Unified Communications Manager
Release 6.x and later
Cisco Unified CallManager Release 5.1,
4.3(2)
SCCPCisco Unified IP Phones 7942G, 7945G, 7962G,
7965G, and 7975G
Cisco Unified Communications Manager
Release 6.x and later
Cisco Unified CallManager Release 5.1
SIPCisco Unified IP Phones 7942G, 7945G, 7962G,
7965G, and 7975G
Firmware Release 9.3(1)SR2 is designed and tested to interoperate with Cisco call control, most notably
Cisco Unified Communications Manager Release 9.0(1). Although SIP firmware is IETF RFC 3261
compliant, it is not supported by Cisco TAC or Engineering for use with non-Cisco call control systems.
Note
Cisco Unified IP Phone 7900 Series Release Notes for Firmware Release 9.3(1)SR2
2
Cisco Unified IP Phone 7900 Series Release Notes for Firmware Release 9.3(1)SR2
Introduction
To Next Page
Loading...
Need help?
General