You can search for problems by using the Cisco Software Bug Toolkit.
To use the Software Bug Toolkit, follow these steps.
Before You Begin
To access Bug Toolkit, you need the following items:
•
Internet connection
•
Web browser
•
Cisco.com user ID and password
Procedure
Step 1
To access the Bug Toolkit, go to:
http://tools.cisco.com/Support/BugToolKit/action.do?hdnAction=searchBugs
Step 2
Log in with your Cisco.com user ID and password.
Step 3
To look for information about a specific problem, enter the bug ID number in the Search for Bug ID field,
then click Go.
Open caveats
The following table lists severity 1, 2, and 3 defects that are open for the Cisco Unified IP Phones that use
Firmware Release 9.3(1)SR2.
For more information about an individual defect, you can access the online record for the defect by clicking
the Identifier or going to the URL that is shown. You must be a registered Cisco.com user to access this online
information.
Because defect status continually changes, the table reflects a snapshot of the defects that were open at the
time this report was compiled. For an updated view of open defects, access Bug Toolkit as described in Access
Cisco Software Bug Toolkit, on page 10.
Table 2: Open caveats for Firmware Release 9.3(1)SR2
HeadlineIdentifier
MIDP Mutable image is not displayed on a 7941CSCsy82318
phone stuck during PFS upgrading/downgradingCSCtj61369
FR23:When pull out the net,use a https connection, wait no time out.CSCtk56477
IDH: Cisco IP phone 7941 does not send out CDP during bootupCSCtl83604
LSC install/upgrade failed or cancelled when CCM Failover/FallbackCSCtn25563
Cisco Unified IP Phone 7900 Series Release Notes for Firmware Release 9.3(1)SR2
11
Cisco Unified IP Phone 7900 Series Release Notes for Firmware Release 9.3(1)SR2
Open caveats
To Next Page
Loading...
Need help?
General