Cisco WAP371 User Manual

Cisco WAP371 Wireless Access Point 10
Because the factory default IP address configuration is DHCP, make sure
that your DHCP server is running and can be reached. You may need to
disconnect and reconnect the devices for them to discover their new IP
addresses from the DHCP server. You can then query the DHCP server for
the new IP address. See Step 2 of Getting Started with the
Configuration, page 7 for more information on how to find the DHCP
address.
If the wireless access points do not receive a DHCP response (there is no
DHCP server on your network) after 60 seconds, the access points will
fallback to the following default static IP address: 192.168.1.245 and a
default mask of 255.255.255.0. To reach that IP address, be sure that your
computer is on the 192.168.1.xxx network.
Rebooting the Devices or Returning them
to their Factory Default Settings
To reboot your device:
• If the Cisco WAP371 uses a power adapter, with the power on, use the
POWER button to reboot the device. The POWER button only functions
when the Cisco WAP371 uses a power adapter.
• When the power supply is PoE, unplug your Ethernet connection for
three seconds and plug it back in.
or
• With the power on, press the Reset button with an opened paperclip for
less than three seconds, or until the lights go off.
– When all the lights go off, release the Reset button.
– Release the Reset button as soon as the lights go off, or you will
restore the device to factory default settings and lose your
configurations.
To reset the device to factory default settings:
• With the power on, press and hold the Reset button with an opened
paperclip for more than 10 seconds.
– All of the lights will go off.
– Release the Reset button when the power light turns on.
8

Cisco WAP371 Specifications

General

Modulation	OFDM
Frequency band	2.4 - 5 GHz
Number of users	64 user(s)
Channel bandwidth	80 MHz
Channels quantity	21 channels
Networking standards	IEEE 802.11ac, IEEE 802.11b, IEEE 802.11e, IEEE 802.11g, IEEE 802.11i, IEEE 802.11n, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Quality of Service (QoS) support	Yes
Flash memory	128 MB
Internal memory	256 MB
Operating system installed	Linux
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	HTTPS, SSID, WPA, WPA2
Antenna features	Integrated antenna
Antenna direction type	Omni-directional
Antenna gain level (max)	2 dBi
Power consumption (typical)	17 W
Internal	No
Product color	White
LED indicators	LAN, Power, WLAN
Cable lock slot type	Kensington
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Width	230 mm
Height	43 mm
Weight	740 g