3 Cisco WAP371 Wireless Access Point
Mounting the Cisco WAP371 Wireless-AC/
N Dual Radio Access Point with Single
Point Setup
You can place your access point on a desktop, or mount it on a wall or
ceiling.
Placement Tips
• Ambient Temperature—To prevent the access point from overheating,
do not operate it in an area that exceeds an ambient temperature of
104°F (40°C).
•Air Flow—Both side panels have vents that must be unobstructed to
prevent overheating.
• Mechanical Loading—The device should be level, stable, and secure
to prevent it from sliding or shifting out of position.
Wall and Ceiling Mounting
The Cisco WAP371 device can be wall or ceiling-mounted. A mounting kit
is packaged with your device. The kit is designed to install your device to
the wall or the ceiling.
The mounting bracket has some flexibility so that you can reuse existing
holes drilled for a Cisco WAP551 or WAP561 device. The installer can
remove the Cisco WAP551 or WAP561 and mount the Cisco WAP371.
The dimensions for the mount kit screws are as follows:
1 .31 to .33 in
(7.8 to 8.3 mm)
2 .86 to .88 in (21.8
to 22.3 mm)
3 .22 to .24 in
(5.5 to 6.0 mm)
4 .69 to .72 in
(17.5 to 18.2
mm)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
