Cisco Wap581 User Manual

Cisco WAP125 Quick Start Guide 11
255.255.255.0. To reach that IP address, be sure that your computer is on the
192.168.1.xxx network.
8 Rebooting the Devices or Returning them to their
Factory Default Settings
To reboot your device:
• The Cisco WAP581 uses PoE power supply; unplug your PoE port Ethernet
connection for three seconds and plug it back in.
or
• With the power on, press the Reset button with an opened paper clip for less
than three seconds, or until the lights go off.
– When all the lights go off, release the Reset button.
– Release the Reset button as soon as the lights go off, or you will restore
the device to factory default settings and lose your configurations.
To reset the device to factory default settings:
With the power on, press and hold the Reset button with an opened paper clip for
more than 10 seconds. The system light will go off.
Release the Reset button when the system light turns on.
9 Where to Go from Here
Support
Cisco Support
Community
www.cisco.com/go/smallbizsupport
Cisco Support and Resources
www.cisco.com/go/smallbizhelp
Phone Support Contacts
www.cisco.com/en/US/support/
tsd_cisco_small_business
_support_center_contacts.html

Cisco Wap581 Specifications

General

Brand	Cisco
Model	Wap581
Category	Wireless Access Point
Language	English