3
Cisco WRP500 Wireless-AC Broadband Router with 2 Phone Ports Quick Start Guide
Cisco WRP500 Wireless-AC Broadband Router with 2 Phone Ports Quick Start Guide
Get to Know the Cisco WRP500
Back Panel
Wireless (Green): The LED shines steadily when the wireless feature is enabled. The LED
flashes when the router is actively sending or receiving data over the wireless network.
Phones 1-2 (Green): The LED shines steadily when an active line is registered to the
corresponding phone port. The LED flashes slowly when voicemail messages are waiting.
Mobile network connection: If a compatible USB modem is installed, the mobile network
connection is used as a failover when an Ethernet connection is unavailable. The Power
LED indicates the status of the mobile network connection:
• Steady Green: The mobile network connection is not in use.
• Flashing Green: The WRP500 is attempting to connect to the internet through the
mobile network connection.
For information about compatible USB devices, see
http://www.cisco.com/c/en/us/products/unified-communications/wrp500-wireless-ac-broa
dband-router-2-phone-ports/index.html
Wi-Fi Protected Setup (Green): The LED shines steady green while wireless security is
enabled. The LED is off when Wi-Fi Protected Setup is disabled.
Reset: To restore the router’s factory defaults, press and hold the Reset button for
approximately ten seconds.
Phone 2, Phone 1: Use these ports to connect standard analog telephones to the router.
LAN 1, 2, 3, 4: Use these Ethernet ports to connect the router to wired computers and
other Ethernet network devices.
To Next Page
Loading...
Need help?
General
