32
——
3.8 Setting the Long Life Printing (LLP) Function
It can extend the abrasion life of the head-resistant by reducing the pressure to press
the print head against the paper.
The Long Life Printing (LLP) function can be enabled by changing the position of the
projection switch inside the paper cover.
1. Turn off the power.
2. Flip up the cover open lever to open the paper cover.
3. Flip down the projection switches on both sides in the arrow direction with the tip of a
screwdriver.
Flip down the projection switches on the left and right from the standard position to the LLP
position one by one.
4. Close the paper cover rmly until it clicks.
Standard
(Projection switch front view)
LLP
CAUTION
When opening the paper cover, be careful not to touch the entrance of the blade of the auto
cutter.
The print head is very hot immediately after printing. Be careful not to touch it with your
hands.
Do not touch the print head with bare hands or metal objects.
The set position of the projection switches on the left and right must be identical.
When this setting is enabled, the printing density may decrease. If necessary, increase the
printing density or use a paper with excellent coloring properties.
This function reduces physical friction by reducing the head pressure and does not guarantee
friction resistance for all bad quality papers.
Refer to PRECAUTIONS IN HANDLING THE PRINTER
To Next Page
Loading...
Need help?
General
