74
Safety
General safety
recommendations
Do not remove the labels attached in
dierent places on your vehicle. They
include safety warnings as well as
identication information for the vehicle.
For all work on your vehicle, use a
qualied workshop that has the technical
information, skills and equipment required, all
of which a CITROËN dealer is able to
provide.
Depending on country regulations,
certain safety equipment may be
mandatory: high visibility safety vests,
warning triangles, breathalysers, spare bulbs,
spare fuses, re extinguisher, rst aid kit, mud
aps at the rear of the vehicle, etc.
Installing electrical accessories:
– The tting of electrical equipment or
accessories not approved by CITROËN may
cause excessive current consumption and
faults and failures with the electrical system
of your vehicle. Contact a CITROËN dealer
for information on the range of approved
accessories.
– As a safety measure, access to the
diagnostic socket, used for the vehicle's
electronic systems, is reserved strictly for
CITROËN dealers or qualied workshops,
equipped with the special tools required (risk
of malfunctions of the vehicle's electronic
systems that could cause breakdowns or
serious accidents). The Manufacturer cannot
be held responsible if this advice is not
followed.
– Any modication or adaptation not intended
or authorised by CITROËN or carried out
without meeting the technical requirements
dened by the Manufacturer will result in the
suspension of the commercial warranty.
Installation of accessory radio
communication transmitters
Before installing a radio communication
transmitter with an external aerial, you must
without fail contact a CITROËN dealer for
the specication of transmitters which can
be tted (frequency, maximum power, aerial
position, specic installation requirements),
in line with the Vehicle Electromagnetic
Compatibility Directive (2004/104/EC).
Declarations of conformity for radio
equipment
The relevant certicates are available on the
brand website:
http://service.citroen.com/ACddb/
Hazard warning lamps
► Pressing this red button causes all the
direction indicators to ash.
They can work with the ignition switched o.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on
the rate of deceleration, the hazard warning
lamps come on automatically. They switch o
automatically when you next accelerate.
They can be turned o by pressing the button
again.