Basic Operations
Note:
• Be sure to read this chapter referring to the
chapter
"3.
CONTROLS"
A CAUTION
When the unit is turned on, starting and
stopping the engine with its volume
raised
to
the maximum level may harm
your hearings.
Be careful about adjusting the volume.
Power on /
off
Notes:
• Start the engine before using this unit.
• Be careful about using this unit for a long
time without running the engine. If you
drain the car's battery too far, you may not
be
able
to
start the engine and this can
reduce the service life of the battery.
1.
Start the engine. The power button / knob
illumination
on
the unit will light up.
~
EngineON
~
position
2.
Press the [
<!>
] key
on
the front panel to
turn
on
the power under standby mode.
The unit goes back to the last status after
power on.
3.
Press and hold the [
<!>]
key on the front
panel to turn off the power under work
mode.
Mute
Press the [MUTE] key
on
the remote control
to mute the volume from the unit.
Note
Doing the operation above again or adjusting
volume will release muting.
Volume adjustment
Turn the volume knob
on
the front panel or
press the [
..
,
....
] key
on
the remote control.
The adjustable range of volume is 0 to 40.
A CAUTION
While driving, keep the volume level at
which external sounds can be heard.
Playing source selection
Press [SRC] key
on
the front panel and
remote control repeatedly
to
choose desired
playing source.
Notes:
1.
Playing source selection means selecting
work mode, such as DISC mode, Radio
mode, Aux mode, etc.
2.
When some devices are not ready, they
cannot be selected.
Display system time
Press the [ADJ] key
on
the front panel or
[DISP] key on the remote control to switch
the display information, system time and
playing source.
CZ100
9
To Next Page
Loading...
Need help?
General
