Preset
Memory
Function
Preset Memory Function can store up to 24 sta-
tions: six stations for each of FM1, FM2, FM3
and AM.
Note:
• When the preset memory function is used, all the con-
tent
of
the memory will be erased.
Manual
memory
function
1)
Press the [BND] button, and select the band
you want to store
in
the memory.
2)
Press the
[<
...
][
...
>]
button then select the sta-
tion you want to store
in
the memory.
3)
Press and hold the [DIRECT] button for 2
seconds or longer, then the station will be
stored
in
the memory.
Auto
store
function
(Automatic
Station
Store)
1)
Press the [BND] button, then select the band
you want to store
in
the memory.
2)
Press and hold the [PS/AS] button for 2 sec-
onds or longer, then the station at which the
reception is the strongest will be automatical-
ly stored
in
the memory.
Note:
• When the number
of
stations stored is less than six,
the previous content
of
the memory for each direct
button will be retained.
Preset Scanning (Preset Station Scan)
When the [PS/AS] button is pressed, the "SCN"
will indicated preset memory numbers and the
stations are tuned
in
for 7 seconds each
in
the
order
in
which they were stored. Press the
[PS/AS] button again to cancel the preset scan-
ning mode.
Instant
Station Recall (lSR)
With this function, a specific radio station can
be
recalled from any mode.
ISR
memory
1)
Press the [FNC] button, then select the radio
mode.
2)
Select the radio station which you want
to
store
in
the memory.
3)
Press and hold the [ISR] button for 2 seconds
or longer.
Recalling ISR
Press the [ISR] button then the display will show
"ISR", then the radio station previously memo-
rized will
be
selected. Press the [ISR] button
again to disengage the unit from the Recalling
ISR function.
Area
Change
Use this function when you are using the car
stereo anywhere outside the U.S.
Switchable
frequency
spacing
This car stereo is initially set to tune
in
frequen-
cy intervals of
10kHz
for AM and 200 kHz for
FM,
the standard calibrations
in
the U.S. When
using the unit outside the U.S., use the following
procedure to switch the frequency range.
The table below lists the frequency specifica-
tions for the U.S. and other countries.
'.
Iinitial Setting
New Setting
, I
(U.S.
standard)
(outside
U.S)
Frequency
I
spacing
~
10kHz
19kHz
AM
r---
-----
--1---
Frequency
I 530 to
531
to
I
range
~
,710kHz
1,602 kHz
1---
1
.---
--.---.----.-
r-
...
------.--
i FrequencY_I 200
kH
50
kH
I
spacing
z
~
z
FM
~~--
I
Frequency
I 87.9
to
I 87.0 to
I
range
I 107.9 MHz I 108 MHz
Switching
the
area
change
Outside
U.S. (New Setting)
While pressing the [A-M] button, press the [RPT]
button,
then
"outside U.S." will
be
selected.
Inside
U.S.
standard
(Initial
Setting)
While pressing the [A-M] button, press the
[SCN]
button,
then the "U.S. standard" will
be
selected.
12
08335/08235
To Next Page
Loading...
Need help?
General
