Clarion M309 User Manual

English
14 M309
6. OPERATIONS
Note:
• Be sure to read this chapter referring to the front diagrams of chapter “3. CONTROLS” on page 7.
Basic Operations
CAUTION
Be sure to lower the volume before
switching off the unit power or the ignition
key. The unit remembers its last volume
setting.
Turning on/off the power
Note:
1. Press the [SRC] button to turn on the power.
2. Press and hold the [SRC] button (1 sec.) to
turn off the power for the unit.
Note:
• System check
The first time this unit is turned on after the wire
connections are completed, it must be checked
what equipment is connected. When the power
is turned on, the “SYSTEM CHECK” appears in
the display, then the unit returns to the radio
mode.
Selecting a mode
1. Press the [SRC] button to change the
operation mode.
2. Each time you press the [SRC] button, the
operation mode changes in the following
order:
Radio ➜ SIRIUS ➜ (XM) ➜ CD/MP3/WMA/
AAC ➜ USB/MTP/iPod ➜ (CD changer) ➜
AUX1 ➜ AUX2 ➜ Radio...
∗ External equipment not connected with
CeNET is not displayed.
∗ iPod/MTP can connect to this unit via USB
cable.
Adjusting the volume
1. Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
∗ The volume level is from 0 (minimum) to 33
(maximum).
Switching the display
Press the [DISP] button to select the desired
display.
Audio Adjustment
You can adjust a sound effect or tone quality to
your preference.
● Setting the BBE MP
(Sound Enhancement and
Restoration for compressed audio
files)
BBE MP (Minimized Polynomial Non-Linear
Saturation) Process improves digitally
compressed sound, such as MP3, by restoring
and enhancing the harmonics lost through
compression. BBE MP works by regenerating
harmonics from the source material, effectively
recovering warmth, detail and nuance.
∗ This fuction is effective for the audio files in the
CD/MP3/WMA/AAC or USB/iPod mode.
2-1. Press the [x] or [v] button to select
“BBE MP”.
3-1. Press the [ ] or [ ] button to select “ON”
or “OFF”.
∗ The factory default setting is “OFF”.
To change audio setting
1. Press the [AUDIO] button to switch to the
audio adjustment selection display.
2. Then press the [x ] or [v] button to
select the audio adjustment mode.
Each time you press the [x] or [v]
button, the sound adjustment mode
changes as following order:
(“BBE MP”) ↔ “BASS” ↔ “TREBLE” ↔
“BALANCE” ↔ “FADER” ↔ “NO FADER”
∗ In the case of display blinking “ENT”, you
can press the [ ] button to adjust the
setting value.
∗ “BBE MP” can be selected only in the CD/
MP3/WMA/AAC and USB/iPod mode.
3. Press the [ ] or [ ] button to adjust the
selected audio mode.
4. After completing settings, press the
[AUDIO] button to return to the previou s
mode.
M309_ENG.book Page 14 Monday, February 23, 2009 3:04 PM

Clarion M309 Specifications

General

Brand	Clarion
Model	M309
Category	Marine Equipment
Language	English