English
31 M309
XM Satellite Radio Operations
This function is available when a Satellite Radio
Receiver is connected through the CeNET
cable.
This unit can control the following satellite radio
receivers:
• XM Satellite Interface Adapter (Mini-Tuner
Included) : CNP2000UC
Clarion cable for CNP2000UC : CNPCLA1
Note:
• XM and the XM logos are trademarks of XM
Satellite Radio Inc.
Selecting a Satellite Radio mode
1. Press the [SRC] button.
The system changes to the specified
Satellite Radio mode.
Selecting a band
1. Press the [BND] button to select a band.
This changes the reception band as follows:
XM1 ➜ XM2 ➜ XM3 ...
● Information displayed during reception
The following information is displayed when the
satellite radio cannot be received normally.
• When a channel is being tuned in (no signal is
yet received):
“LOADING”
• A channel without a broadcast has been
selected:
“CH UNAVAIL”
Confirming your XM ID
1. Press the [x] or [v] button to switch to
channel 0.
2. Press the [DISP] button until the XM ID
appears in the diaplay.
Displaying channel labels
1. Press the [DISP] button to select the desired
channel label.
Channel ➜ Category ➜ Title (Artist) ...
Channel selection
1. Channels are selected with the [x] or
[v] button.
∗ For details, see the following operation
descriptions.
Note:
• The audio output is muted and other button
operations are not accepted during channel
selection.
Recalling a preset station
A total of 18 satellite radio stations can be
stored.
6-XM1, 6-XM2 and 6-XM3
This allows you to store your favorite satellite
radio stations in memory for later recall.
1. Press the [BND] button to select the desired
band.
2. Press the [ ] / [ ]
button or [DIRECT]
button to select the desired preset station.
Preset memory
1. Press the [BND] button to select the desired
band.
2. Select the desired channel.
3. Press and hold the [DIRECT] button (2 sec.)
to store the current channel into preset
memory.
Receiving stations selected by
category
Satellite Radio allows you to select broadcast
channel category (contents).
1. Press and hold the [BND] button (1 sec.) to
select the category selection mode.
∗ It press once again, return to the channel
selection mode.
2. Press the [ ] or [ ] button to change the
category item.
3. Press the [x] or [v] button to tune in a
station.
Notes:
• When the category selection mode is entered,
the category of the last received channel is
displayed first.
• The category selection mode is canceled when
no channel with the selected category can be
found.
M309_ENG.book Page 31 Monday, February 23, 2009 3:04 PM
To Next Page
Loading...
Need help?
General
