6. OPERATIONS
Basic Operations
Note:
•
Be
sure to read this chapter referring to the
chapter "3. CONTROLS"
I'
A CAUTiON
When
the unit
is
turned
on,
starting and
stopping
the engine with its volume raised to
the maximum level may harm your hearings.
Be
careful about adjusting the volume.
Turning
ON
and
OFF
the
Power
Note:
• Start the engine before using this unit.
• Be careful
about
using this unit for a long
time without running the engine.
If
you
drain
the car's battery too
far,
you
may
not
be
able
to
start the engine
and
this can reduce the
service life
of
the battery.
1. Start the engine. The power button
illumination on the unit will light up.
2.
Press the
[~SRC]
button on the unit
to
turn ON the power.
Or press the
[SRC/POWER] button on the
remote control to turn
ON
the power.
3.
To
turn
OFF
the power, press and hold the
[~SRC]
power button on the unit for
more than 2 seconds.
Or press the
[SRC/POWER] button on the
remote control
to
turn OFF the power for
more than 1 seconds.
~
EngineON
~
position
~
Opening
and
Closing Operational
Panel
Press [OPEN] button on the unit (VZ401).
The operational panel will be open.
Press the same button again
to
close the panel.
I A CAUTiON I
•
Do
not
move
the
operation
panel
forcibly
or
apply
strong
force
to
the
operation
panel.
•
When
the
operation
panel
is
operating,
be
careful
not
to
get
your
hand
or
finger
caught
between
the
operation
panel
and
main
unit
or
its
mechanical
parts.
•
The
driver
should
not
operate
the
operation
panel
while
driving.
Adjusting the Angle
of
the Operational Panel
Touch the settings key to enter into the Monitor
Adjust
to
adjust the desired angle (VZ401).
Selecting a
Mode
1.
Touch the desired source key you wish to
change to:
Tuner,
Disc,
NAVI,
USB, SIRIUS,
AUX
IN,
AV
IN, iPod/iPhone,etc.
*External equipment not connected
to
this
unit is not displayed.
Touch the
[10:00AM] to display the time.
2. Press the
[~]
SRC button
to
scroll through
the available sources.
VX401NZ401 17
To Next Page
Loading...
Need help?
General
