GENERAL
Replace with a fuse
of
the same
amperage. If the fuse blows again,
consult your store
of
purchase.
Press the reset button with a thin
rod.
Note:
When the Reset button is pressed,
turn
off
the ACC power.
* When the Reset button is
pressed, frequencies
of
radio sta-
tions, titles, etc. stored
in
memory
are cleared.
Consult your installation center.
The microprocessor has malfunc-
tioned due
to
noise, etc.
Incorrect wiring.
Display
is
not accurate.
Power does not turn on. (No sound Fuse is blown.
is
produced.)
Nothing happens when buttons are
pressed.
The remote control unit does not
work.
Direct rays of the sun
fallon
the
light-receptive part
of
the remote
control unit.
When direct rays of the sun fall
on the light-receptive part
of
the re-
mote control unit, it may not work.
The battery
of
the remote control
unit
is
dead or there is no battery
in
the remote control unit.
Check the battery of the remote
control unit.
DVDPLAYER
Disc cannot be loaded. A disc is already loaded.
Eject the disc before loading the
new one.
There is foreign matter already in
the disc slot.
Remove the foreign matter, or
consult a service station.
Sound skips or is noisy. Disc is dirty.
Clean the disc with a soft cloth.
Disc is heavily scratched
or
warped.
Replace with a disc
in
good condi-
tion.
Sound is bad directly after power
is
turned on.
Condensation may form on the
internal lens when the car
is
parked
in
a humid place.
Let dry for about 1 hour with the
power on.
Video images are not displayed. The parking brake
is
not engaged.
Check that the parking brake is
engaged.
Disc cannot play with the
display "PARENTAL VIOLATION"
shown.
Feature exceeds set parental level. Release the view limitation or
change the parental level.
See the subsection "Setting up the
parental level"
42 VX401NZ401
To Next Page
Loading...
Need help?
General
