Installation
Page 52
3.After installing the panel, ensure that there is no space
between the unit body and decoration panel. Otherwise
air may leak through the gap and cause dewdrop.
11.2.3 Mount the grille
Ensure that the buckles at the back of the grille be properly
seated in the groove of the panel.
11.2.4 Connect the two wires of the panel to
the main board of the unit.
11.2.5 Fasten the control box lid with two
screws .
11. Panel Installation
11.1
11.2 Cassette 650x650 BOX-SL 2
Panel Installation
11.2.1 Remove the front grille
1. Slide the 2 grille hooks toward the middle of the
decoration panel.
2. Hold the grille at a 45° angle, lift it up slightly and
detach it from the main body.
11.2.2 Install the panel
1.Align the indicate “ ” on the decoration panel to the
indicate “ ” on the unit .
2. Attach the decoration panel to the unit with the
supplied screws as shown in figure below.
To Next Page
Loading...
Need help?
General
