21
GLOBE 3800 MANUEL D’INSTALLATION
1
NE PAS UTILISER
-
-
3
SIRENE A UNE TONALITE FIXE
4
SIRENE A UNE TONALITE ALTERNEE
5
SIRENE A DEUX TONALITES
6
SIRENE AVEC SIGNAL MODULE EN FREQUENCE
activée
activée
activée
activée
désactivée
désactivée
désactivée
désactivée
TABLEAU DE LA SIRENE
Clignotement court
Clignotement long
PROGRAMMATION DE FABRIQUE
28
INSTALLATION MANUAL GLOBE 3800
INTRODUCTION
This manual contains all the information necessary to install the alarm system and to set it up as
required by the customer and/or by the local/insurance directive. Refer to the user manual for a
description of each function.
Each function is described in the user manual while in this manual you will find some suggestions
to follow during the installation.
Functions list
Here following are listed the main functions of the alarm. It is not possible to activate/deactivate
and personalize them.
• arm and disarm via vehicle original remote radio control.
• volumetric protection of the passenger compartment by self adjusting ultrasonic sensor.
• perimetric protection. An alarm condition is triggered if a door, boot or bonnet is opened.
There is a 40 s. set up delay, after arming the system, before the sensors are active.
• hotwire protection. When armed, the immobilizer is active and any attempt at starting triggers
an alarm condition.
• When the alarm is triggered the electronic siren sounds for 30 s. at more than 118 dB (@ 1m)
and the turn indicators flash.
• alarm status LED wich displays also alarm status history.
• safety circuit that ensures that the alarm cannot be armed while the vehicle’s engine is running.
• volumetric ultrasonic sensor and/or external sensor excludable by remote control.
• emergency override (PIN code).
• battery back up protection.
• garage function.
• signal of opened doors/bonnet/boot.
• arm/disarm blinker.
• automatic arming.
• immobilizer automatic arming.
• immobilizer alarm.
• immobilizer auto re-arm.
• alarm auto re-arm.
• automatic anti hi-jack.
• voluntary anti hi-jack.
• anti hi-jack immobilization controlled by movement sensor (VSS input).
•
perimetric input polarity setting procedure
Siren sound selection list
It is possible to select one of the four siren sounds:
• fixed monotonal siren.
• alternating monotonal siren.
• bitonal siren.
• sweep siren type.
Please refer to the sirens table of the programming tables.
06DE2086A.pmd 17/01/2005, 14.3021