User instructions
EN
Wait that the tub is charged ( “S3” START button GREEN) and for the water to reach the set temperature of
about 55 ° C.
At this point it is possible to start the washing cycle.
It is important to know that:
• the activation of a cycle is shown by the sequential lighting of the indicator lights of the display and S3
START button BLUE;
• during the wash phase and drain the tub temperature is displayed;
• during the rinse phase the boiler temperature is displayed.
IMPORTANT
N.B.: Machine in conformity with the existing hygienic standards, guaranteeing a final rinse at 85°C.
Wash cycle automatically lengthened if final rinse temperature is not reached.
To avoid the machine blocking, after 8 minutes the cycle will be ayway completed.
1.1.d Interruption and end of wash cycle
5. It is possible to momentarily interrupt the wash cycle by opening the door; the operations will resume by
closing it.
Turning off the machine using the “Q1” switch terminates all active cycles.
Upon turning on the machine again, the indicator light of the last cycle selected will light and the display will
show the alarm code “A. .1.” until a new cycle starts.
1.1.e Self cleaning and drain cycle
6. At the end of the wash operations turn off the machine by pressing the “Q1” switch.
After having removed the overflow pipe and closed the door, press the “S3” button for 3 sec.
The self cleaning and drain cycle will start, turning on the drain pump for machines equipped with it.
(*) The display will show “C. .1.” during the entire cycle (2 min. and 30 sec.).
At the end of the autowash cycle, remove the tank filter to clean and replace along with the overflow hose in
the correct position. For further information regarding the accessories please look under the section “USEFUL
INFORMATION”.
1.1.f Manual drain
7. It is possible to empty the tank at any time of the day.
With the machine off, take out the overflow pipe from the tank and wait until it is completely empty.
For machines equipped with drain pump it is possible to empty the tank by starting the manual drain
cycle during which only the drain pump is active.
It is possible to perform this cycle only with the machine turned on.
After having taken out the overflow pipe, press the “S9” button for 5 sec. The drain cycle will start.
* The display will show “C. .2.” for the entire duration of the cycle (2 min. and 20 sec.).
At the end of the cycle it is recommended to remove the filters of the tank for cleaning and then put them back
with the overflow pipe in their positions.
37
To Next Page
Loading...
Need help?
General
