Sears offers many useful accessories for your garage door opener. They are illustrated below with
Sears model numbers and descriptions.
139.53684
139.53681
139.53703
53589
139.53686
139.53702
SECURITY✚ Compact
3-Function Remote Control:
With loop for attaching key ring.
SECURITY✚ 3-Function Remote
Control:
Includes visor clip.
SECURITY✚ Keyless Entry:
Enables homeowner to operate garage
door opener from outside by entering a
password. Also can add a temporary
password for visitors or service
persons. This temporary password can
be limited to a programmable number
of hours or entries.
Outdoor Key Switch:
Operates the garage door
automatically from outside when
remote control is not handy.
Plug-In Light Control:
Enables homeowner to turn on a
lamp, television or other appliance
from car, bedside, or anywhere in
the home with a remote.
Emergency Key Release:
Required
for a garage with NO
access door. Enables homeowner
to open garage door manually from
outside by disengaging trolley.
Support Brackets:
For finished ceilings or where
additional support is required,
based on garage construction.
Includes brackets and fastening
hardware.
Door Clearance Brackets:
(
For Sectional Doors Only
)
Replaces top brackets and rollers on
door to reduce height of door travel.
For use when installing opener in
garage with low headroom clearance.
10 Foot Rail Extension:
To allow a 10 foot door to open fully.
8 Foot Rail Extension
To allow an 8 foot door to open fully.
139.53804
139.53805
139.53709
139.53680
38
Accessories
We recommend that you program your password
before you install the Keyless Entry. You will not
need assistance, and you can test the reception at
the mounting location before installation.
If you have a Premium Control Console:
1.
With the door closed,
press the four digit password
desired, then press and hold Enter.
2. Press and hold the light button on the door control.
3. Press and hold the door control push bar.
4. After the opener light flashes, release all buttons.
If you do not have a Premium Control Console:
1. Choose a 4-digit password using numbers from
0 to 9 (a number can be used more than once, for
example, 4, 0, 4, 1).
2. Press the four buttons for the password, then
press and
hold
the Enter button. The indicator light
on the door opener panel will blink.
3. Press and release the SRT (learn) button on the
opener panel. After the opener light flashes,
release the Enter button.
Test by pressing the password, then press Enter. The
door should begin to move.
To Add the Keyless Entry
To Next Page
Loading...
Need help?
General
