21
ENGLISH
can return it within 90 days from the date of purchase with
a receipt for a full refund – no questionsasked.
LATIN AMERICA: This warranty does not apply to products
sold in Latin America. For products sold in Latin America,
see country specific warranty information contained in
the packaging, call the local company or see website for
warrantyinformation.
FREE WARNING LABEL REPLACEMENT: If your warning
labels become illegible or are missing, call 1-888-331-4569
for a freereplacement.
TROUBLESHOOTING GUIDE
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
TROUBLE! WHAT’S WRONG? WHAT TO DO
Saw will not start Battery not installed. Install battery. Refer to Installing and Removing the Battery Pack.
Battery not charged. Charge battery. Refer to Charging a Battery.
Brushes worn out. Have brushes replaced by authorized service center.
Saw makes unsatisfactory cuts Dull blade. Replace blade. Refer to Changing or Installing a New Saw Blade.
Blade mounted backwards. Turn blade around. Refer to Changing or Installing a New Saw Blade.
Gum or pitch on blade. Remove blade and clean with coarse steel wool and turpentine or
household oven cleaner.
Incorrect blade for work being done. Change the blade type. Refer to Saw Blades under Optional Accessories.
CUTLINE worklight is flashing Battery not charged. Charge battery. Refer to Charging a Battery.
Machine vibrates excessively Saw not mounted securely to stand
or work bench.
Tighten all mounting hardware. Refer to Bench Mounting.
Stand or bench on uneven floor. Reposition on flat level surface. Refer to Familiarization.
Damaged saw blade. Replace blade. Refer to Changing or Installing a New Saw Blade.
Does not make accurate miter cuts Miter scale not adjusted correctly. Check and adjust. Refer to Miter Control under Features and Controls.
Blade is not square to fence. Check and adjust. Refer to Miter Control under Features and Controls.
Blade is not perpendicular to table. Check and adjust fence. Refer to Bevel Square to Table Adjustment
under Adjustments.
Workpiece moving. Clamp workpiece securely to fence or glue 120 grit sandpaper to fence with
rubber cement.
Kerf plate worn or damaged. Take to authorized service center.
Material pinches blade Cutting bowed material. Refer to Bowed Material under Special Cuts.
To Next Page
Loading...
Need help?
General