Crestron MP-AMP30 User Manual

Media Presentation Audio Amplifier Crestron MP-AMP30
Setup
Installation
Mount the MP-AMP30 to a flat surface near the audio source equipment, using four
screws (not supplied).
Hardware Hookup
Hardware Connections for the MP-AMP30
Before applying power, do the following:
1. Make sure the shunt jumpers are properly positioned for stereo (ST) or
mono (MO) audio. (Refer to diagram on unit.)
2. Connect all input and output cables (refer to the above illustration).
3. Set the BASS and TREBLE controls to their default center detent
positions, and set the VOL control to a low (counterclockwise) position.
Apply power and verify operation as follows:
1. With the 24VDC power source connected, the green LED should be
illuminated.
2. Slowly turn the VOL control clockwise until the audio is at a comfortable
level.
3. Adjust the TREBLE and BASS controls to suit personal preference.
6 • Media Presentation Audio Amplifier: MP-AMP30 Operations & Installation Guide – DOC. 6917B

Crestron MP-AMP30 Specifications

General

Brand	Crestron
Model	MP-AMP30
Category	Amplifier
Language	English