Crestron MP-AMP30 User Manual

Media Presentation Audio Amplifier Crestron MP-AMP30
Installation and setup of the MP-AMP30 is simple. Detachable output connectors
facilitate the termination of speaker wiring up to 16 gauge. RCA inputs connect
directly to the line output of a video projector or display, audio processor, mixer, or
AV switcher. Rotary controls provide for adjusting the overall speaker volume, as
well as bass and treble. For quiet environments, loudness compensation is employed
by setting the volume control below the center detent position.
Applications
The following diagram shows an MP-AMP30 in a typical application.
Specifications
Specifications for the MP-AMP30 are listed in the following table.
MP-AMP30 Specifications
SPECIFICATION DETAILS
Audio
Input Volume Range
Loudness
Bass Gain Range
Treble Gain Range
Frequency Response
S/N Ratio
THD+N:
Output Power
-55dB to +20dB
Active at volume settings below center detent
±15dB @ 100Hz
±15dB @ 10kHz
20Hz to 20kHz ±0.5dB
75dB 20Hz to 20kHz A-weighted
0.7% 20Hz to 20kHz
15 Watts per channel at 8 or 4 Ohms
Power Requirements
Power Consumption
48 Watts (2.0 Amps @ 24 Volts DC) Power supply
included
(Continued on following page)
2 • Media Presentation Audio Amplifier: MP-AMP30 Operations & Installation Guide – DOC. 6917B

Crestron MP-AMP30 Specifications

General

Brand	Crestron
Model	MP-AMP30
Category	Amplifier
Language	English