Crestron RMC3 User Manual

Crestron RMC3 3-Series Room Media Controller
Setup
Network Wiring
When wiring the Cresnet/Ethernet network, consider the following:
 Use Crestron Certified Wire.
 Use Crestron power supplies for Crestron equipment.
 Provide sufficient power to the system.
CAUTION: Insufficient power can lead to unpredictable results
or damage to the equipment. Use the Crestron Power Calculator to
help calculate how much power is needed for the system
(www.crestron.com/calculators
).
For networks with 20 or more devices, use a Cresnet Hub/Repeater
(CNXHUB, sold separately) to maintain signal quality.
For more details, refer to “Check Network Wiring” on page 29.
Identity Code
NOTE: The latest software can be downloaded at
www.crestron.com/software.
Net ID
The Net ID of the RMC3 has been factory set to 02. The Net ID is
defined as the “Master” control system on the Cresnet network and
cannot be changed.
IP ID
The IP ID is set within the RMC3’s IP table using Crestron Toolbox.
For information on setting an IP table, refer to the Crestron Toolbox
help file.
Operations
& Installation Guide – DOC. 7558B Room Media Controller: RMC3  15

Crestron RMC3 Specifications

General

Internal memory	0.256 GB
Storage media type	Flash
Internal storage capacity	4096 GB
Product color	Black
Heat dissipation	17 BTU/h
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Ethernet LAN (RJ-45) ports	1

Weight and Dimensions

Depth	73 mm
Width	128 mm
Height	35 mm
Weight	180 g