EasyManuals Logo
Home>Cub Cadet>Trimmer>CC 3075

Cub Cadet CC 3075 User Manual

Cub Cadet CC 3075
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Section 7
Troubleshooting
CAUSE
On/Off stop control is in the OFF position
Empty fuel tank
Primer bulb wasn't pressed enough
Engine is flooded
Old or improperly mixed fuel
Fouled spark plug
Plugged spark arrestor
CAUSE
Air filter is plugged
Old or improperly mixed fuel
improper carburetor adjustment
CAUSE
Old or improperly mixed fuel
improper carburetor adjustment
Cutting attachment bound with grass
Dirty air filter
Plugged spark arrestor
CAUSE
Old or improperly mixed fuel
improper carburetor adjustment
Fouled spark plug
Plugged spark arrestor
CAUSE
Cutting attachment bound with grass
Cutting attachment out of line
inner reel bound up
Cutting head dirty
Line welded
Line twisted when refilled
Not enough line is exposed
CAUSE
Oil, cleaner or lubricant in cutting head
ACTION
Turn the on/off stop control to ON
Fill fuel tank with properly mixed fuel
Press primer bulb fully and siowiy 10 times
Squeeze the trigger, put lever in Position 2 and pull
the starter rope
Drain gas tank and add fresh fuel mixture
Replace or clean the spark plug
Clean or replace spark arrestor
ACTION
Replace or clean the air filter
Drain gas tank and add fresh fuel mixture
Adjust according to the CarburetorAdjustmenta section
ACTION
Drain gas tank and add fresh fuel mixture
Take to an authorized service dealer for an adjustment
Stop the engine and clean the cutting attachment
Clean or replace the air filter
Clean or replace spark arrestor
ACTION
Drain gas tank and add fresh fuel mixture
Take to an authorized service dealer for an adjustment
Replace or clean the spark plug
Clean or reptace spark arrestor
ACTION
Stop the engine and clean cutting attachment
Refill with new line
Replace the inner reel
Clean inner reel and outer spool
Disassemble, remove the welded section and rewind
Disassemble and rewind the line
Push the bump knob and pull out line until 4 inches
(102 mm) of line is outside of the cutting attachment
ACTION
Clean and thoroughly dry the cutting head
If further assistance is required, contact your authorized service dealer.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet CC 3075 and is the answer not in the manual?

Cub Cadet CC 3075 Specifications

General IconGeneral
BrandCub Cadet
ModelCC 3075
CategoryTrimmer
LanguageEnglish

Related product manuals