Section3
Assembly
Shaft Grip
(4) Screws =_ _ _1_
Shaft ==
Housing ==
=,
Minimum 6 inches
(15i24 cm)
D-Handle
Bottom Clamp
(4) Nuts .......
Fig,3-1 (ifused)
Install and Adjust the D-handle
1. Remove the screws and bottom ciamp piece that
were installed on the D-handle for shipping.
2. Place D-handle over the shaft housing and onto the
bottom clamp (Fig. 3-1). Place it a minimum of 6
inches (15.24 cm) from the end of the shaft grip.
3. Start screws with a large Fiat-head or T-25 Torx
screwdriver. Do not tighten until you make the
handle adjustment.
4. If it was pre-installed, loosen the screws on the
D-handlejust enough to move the D-handle.
5. While holding the unit in the operating position
(Fig. 3-2), move the D-handle to the location that
provides you the best grip.
6. lighten the clamp screws evenly, until the D-handle
is secure.
Fig. 3-2
¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸7¸
To Next Page
Loading...
Need help?
General
