13
CHAPTER 8: RADIO FREQUENCY (RF) INTERFERENCE
Radio frequency (RF) interference with other devices may cause intermittent loss of information. Wireless Internet access
points, microwaves, cordless phones, or other wireless devices may cause frequency interference. To mitigate the chance
of interference, set wireless access points to the lowest channel possible and keep indoor cycles away from interfering de-
vices. To change the channel on the access point, please consult manufacturer’s documentation.
CycleOps utilizes ANT+ and Bluetooth Smart technology to ensure a robust and reliable connection between the various
sensors used in our products. Sensors are dened as power meter sensors, heart rate strap sensors, cadence sensors,
speed sensors, and controlled resistance sensors.
Statement of Compliance for FCC and Industry Canada:
This device complies with Industry Canada and Part 15 of the FCC Rules. Operation is subject to the following two con-
ditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The term “IC” before the radio certication number only signies that Industry Canada technical specications were met.
Changes or modications to this device not expressly approved by the party responsible for compliance with FCC regula-
tions (the manufacturer) could void the user authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit difference from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CHAPTER 9: IMPORTANT PRECAUTIONS
It is the responsibility of the owner to ensure that all users of this CycleOps Phantom Series indoor cycle are adequately
informed of all warnings and precautions. For questions regarding this guide, contact Customer Service at the number
listed on the back panel of this guide.
WARNING: Always consult with a physician before beginning or modifying any exercise program.
• Stop exercising, if experiencing any kind of pain, including but not limited to: chest pains, nausea, dizziness, or short-
ness of breath and consult a physician before continuing.
• Always wear proper footwear while using this equipment.
• Do not jump on the indoor cycle.
• Keep power cord away from heated surfaces (Phantom 5 only).
• Unplug indoor cycle before moving or cleaning it (Phantom 5 only). To clean, wipe surfaces down with soap and
slightly damp cloth only; never use solvents (see Preventative Maintenance).
Crank Arm Length 170mm
PowerTap Accuracy +/-1.5% (Phantom 3 & 5 only)
Signal Transmission: ANT+ / BLE
Operational Temperature 0 to 40 degrees Celsius or 32 to 104 Fahrenheit
Battery Life (Hub) 1000 hours approx.
Battery Life (Joule) 20 hours approx.
Hub battery type: two AA type 1.5 volt
Joule battery type: rechargeable
Freehub xing bolt torque 300 inch-lbs.
To Next Page
Loading...
Need help?
General
