17D-Link DCS-2332L User Manual
Section 1: Product Overview
LENS
IR LIGHT
WPS LED
LIGHT SENSOR
MIC
POWER LED
PIR
RJ45
SPEAKER
ATENNA
DC JACK
WPS SW
RESET SW
MICRO SD
DCS-2332L
To create a WPS connection:
Step 1
Locate the antennas included with your DCS-2332L and attach it to the antenna
connector located on the side of the Network Camera.
Step 2
Press and hold the WPS button for approximately 5-6 seconds. The blue WPS
status LED on the front panel will blink.
Step 3
Within 60 seconds press the WPS button on your router. On some routers, you
may need to log into the web interface and click on an on-screen button to
activate the WPS feature. If you are not sure where the WPS button is on your
router, please refer to your router’s user manual.
The DCS-2332L will automatically create a wireless connection to your router.
While connecting, the status LED will ash. When the connection process is
complete, the status LED will turn solid.
Note: If your router does not support WPS, you can still use the wired connection
method on the previous page. After Zero Conguration setup is complete, your router's
wireless settings will be automatically transferred to the camera.
Optional: WPS Wireless Connection
If your router supports WPS, you can use the WPS button on the camera to easily create a secure wireless connection to your
network.
WPS Button
2
1
To Next Page
Loading...
Need help?
General
Weight and Dimensions
