D-Link DES-1024D User Manual

4
Switching LAN technology is a marked improvement over the previous
generation of network hubs and bridges, which were characterized by higher
latencies. Routers have also been used to segment local area networks, but
the cost of a router, the setup and maintenance required, make routers
relatively impractical. Today switches are an ideal solution to most kinds of
local area network congestion problems.
Features
The DES-1024D is a high-performance switch designed specifically for
environments where traffic on the network and the number of users increase
continuously.
 24-port 10/100BASE Ethernet Switch with RJ-45 connectors
 Supports Auto-negotiation of speed and duplex modes for
each port
 Supports Auto-MDI/MDI-X on each port, eliminating the
need for cross over cables or uplink ports
 Wire-speed reception and transmission
 Store-and-Forward switching method
 Integrated address Look-Up Engine, supports 8K MAC
addresses
 Supports 2.5Mbps RAM for data buffering
 Front-panel diagnostic LEDs
 Broadcast storm protection
 IEEE 802.3x flow control for full-duplex
 Back pressure flow control for half-duplex

D-Link DES-1024D Specifications

General

MAC address table	8000 entries
Store-and-forward	Yes
Maximum data transfer rate	0.1 Gbit/s
Supported data transfer rates	10/100 Mbps
10G support	No
Networking standards	IEEE 802.1Q, IEEE 802.3, IEEE 802.3az, IEEE 802.3i, IEEE 802.3u
Switch type	Unmanaged
Switch layer	L2
Power connector	DC-in jack
Basic switching RJ-45 Ethernet ports quantity	24
Safety	UL
Product color	Black
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 90 %
Dimensions (WxDxH)	280 x 44 x 180 mm
Networking features	Fast Ethernet
Connectivity technology	Wired
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	1900 g