D-Link DIR-612 User Manual

72D-Link DIR-612 User Manual
Appendix B - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP
server (i.e. wireless router) automatically. To verify your IP address, please follow the steps below.
Click on Start > Run. In the run box type cmd and click OK. (Windows® 7/Vista® users type cmd in the Start Search box.)
At the prompt, type ipcong and press Enter.
This will display the IP address, subnet mask, and the
default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation,
security settings, and the settings on your router.
Some rewall software programs may block a DHCP
request on newly installed adapters.

D-Link DIR-612 Specifications

Wireless Signal Rates

IEEE 802.11n maximum signal rate	300 Mbps
IEEE 802.11g signal rates	54 Mbps, 48 Mbps, 36 Mbps, 24 Mbps, 18 Mbps, 12 Mbps, 11 Mbps, 9 Mbps, 6 Mbps

Wireless Frequency Range

Wireless frequency range (Europe)	2.4 GHz to 2.4835 GHz

Operating Environment

Operating temperature	0 °C to 40 °C (32 °F to 104 °F)
Storage temperature	-20 °C to 65 °C (-4 °F to 149 °F)
Humidity range	10% to 95% (non-condensing)

Weight and Dimensions

Dimensions	175 x 150 x 31 mm (6.89 x 5.9 x 1.22 inches)