D-Link DSL-2520U Quick Installation Guide

DSL-2520U Quick Installation Guide
PC with USB Port
!
Do not connect your router to your PC until the USB driver is installed.
1. Turn on your computer and wait until the operating system is completely
loaded.
2. Download the Setup.exe file from D-Link website
(ftp.dlink.ru/pub/ADSL/DSL-2520U/Drivers/) and run it. Wait until the
USB driver installation is completed and click the Finish button.
3. Connect a phone cable between the DSL port of the router and the ADSL
OUT port of the splitter. Connect your phone to the PHONE port of the
splitter. Then connect another phone cable between a phone jack and the
ADSL IN port of the splitter.
4. Connect the power cord to the power connector port on the back panel of
the router, then plug the power adapter into an electrical outlet or power
strip.
5. Turn on the router by pressing the ON/OFF button on its back panel.
6. Connect the USB cable between the USB port located on the back panel
of the router and the USB port of your PC.
4

D-Link DSL-2520U Specifications

Data Transfer Rates

ADSL full rate downstream	up to 8 Mbps
ADSL full rate upstream	up to 1 Mbps
G.lite downstream	up to 1.5 Mbps
G.lite upstream	up to 512 Kbps
G.dmt.bis full rate downstream	up to 12 Mbps
G.dmt.bis full rate upstream	up to 12 Mbps
ADSL2 full rate downstream	up to 24 Mbps

Interfaces

ADSL interface connector	RJ-11
LAN interface	RJ-45 port for 10/100BASE-T Ethernet
USB interface	USB port Type B connector, USB 1.1 Specification