DSL-2740U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
Installation and Connection
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
specify the settings of the firewall, etc.)
Start a web browser (see the Before You Begin section, page 13). In the address bar of the web
browser, enter the IP address of the router (by default, the following IP address is specified:
192.168.1.1). Press the Enter key.
Figure 15. Connecting to the web-based interface of the DSL-2740U device.
!
If the error “ The page cannot be displayed ” (or “ Unable to display the page ”/“ Could not
connect to remote server ”) occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the Initial
Configuration Wizard section, page 34).
Figure 16. The page for running the Initial Configuration Wizard.
Page 27 of 174
To Next Page
Loading...
Need help?
Data Transfer Rates
