DSL-310 ADSL Modem User’s Guide
WAN
WAN is short for Wide Area Network. The WAN settings can be referred to as the Public settings. All IP
information in the WAN settings are public IP addresses which are accessible on the Internet.
PVC:
Leave this set at the default value 0 the first time the Modem is set up. For more information on this
option see Multiple PVC Operation.
VPI:
If instructed to change this, type in the VPI value for the initial connection.
VCI:
If instructed to change this, type in the VCI value for the initial connection.
Connection Type:
Change connection method and packet encapsulation technique as instructed by
your ISP. The available connection types are 1483 Bridge LLC, 1483 Bridge VC-Mux, form the pull-down
menu. Default Connection Type = 1483 Bridge LLC.
Virtual Circuit:
Selection Enable or Disable.
ATM
Service Category:
UBR and CBR are supported form the ATM.
Bandwidth:
Bandwidth setting takes effect only when the CBR is selected. The maximum available
bandwidth is from the upstream data rate of ADSL status page.
To Next Page
Loading...
Need help?
General
