<OIL LEVEL>
●Start the engine and let it idle for a few
minutes.
●Stop the engine and put the motorcycle
on its mainstand on level ground.
●Remove the L. crank case cover.
●Remove the oil check bolt and make
sure that the oil level is up to the lower
edge of the bolt hole.
●If the level is low, release the
transmission oil filler ACG cap or the
L.crankcase until the oil overflow
through oil hole and fill the
recommended oil slowly.
RECOMMENDED OIL : SAE # 80~90
●Reinstall the oil check bolt, the cap, and
the L.crankcase cover.
<FLUID LEAK>
Check to see if transmission oil leaks out
of the transmission case.
Check the tire pressure using a tire gauge.
Check tire pressure when the tires are cool.
37
TRANSMISSION OIL INSPECTION TIRE PRESSURE INSPECTION
CAUTION
●Pay special attention not to let
rubber etc., enter the check bolt
hole.
●When draining the oil, make sure
that all of the oil is removed.
●The engine can be harmed if there
is too much or not enough oil.
●Do not use other manufacturers oil
or low-quality oil. These oils can
change quality overtime and can
cause damage.
CAUTION
●If there is an improper amount of
air in the tires, or if there are
cracks, damage or abnormal wear
on tires, this may cause unstable
steering or may allow the tires to
become easily punctured.
AIR PRESSURE
(kgf/㎠)
1 PERSON
RIDING
FRONT
1.75
2.00
1.75
2.00
REAR
REAR
FRONT
2 PERSON
RIDING
OIL HOLE
OIL CHECK BOLT
OIL BOLT HOLE
**E-5 OWNERS(1~47) 02.11.5 4:3 PM 페이지37
To Next Page
Loading...
Need help?
General
