Vehicle Systems Disassembly & Assembly
NOTE:
The following steps are for assembly of the
parking brake.
3. Put the strap assembly in position on bracket
assembly (8). Install bracket assembly (3).
4. Install spring (6), bolt (7) and the wire. Install ring
(2), spring (1) and retaining nut (5).
End By:
a. Install parking brake.
Drive Motor
Remove And Install Drive Motor
1. Remove the battery, the plate under the battery
and the floor plates. Drain the hydraulic tank.
Disconnect the hydraulic pump and steering pump
hoses from the hydraulic tank.
2. Remove nut (3) and the spacers from the end of
the parking brake cable assembly. Loosen the bolt
and clamp (1), and pull the cable assembly away
from the parking brake.
3. Disconnect thermal switch connector (2).
Disconnect brush wear indicator wire (4).
Disconnect four cables (5) (two at the back and
two at the front) from the drive motor.
Tools Needed A B
Link Bracket 1
Socket 1
63
IDCD345S
To Next Page
Loading...
Need help?
General
