Installing the remote control batteries
1 Open the battery compartment on the back of the
remote control.
2 Install two AAA size batteries as shown. Make sure
the “+” and “–” terminals are oriented correctly.
3 Replace the cover.
Using the remote control
Hold the remote control within an angle range of about
30° from either side of the remote sensor. The remote
control range is about 23 feet (7m) from the VCR.
Point the front of the remote control directly at the front
of the VCR.
Overview of the equipment,
continued
✔
• Do not mix different types
of batteries, or mix an old
and a new battery.
• Remove and replace
weak batteries. Weak
batteries can leak and
damage your controller.
Dispose of batteries
properly; never throw
them into a fire.
65
13 P/S
Press to pause video tape playback for temporarily
still picture. Each press of the button advances the
picture one frame.
14 100
Press in combination with the 0-9 buttons to select
channels greater than 100.
15 FF
Press to fast forward a video cassette.
16 –CH/TRK+
Press to change the channel (channels stored in
memory only) or to adjust the tracking during
playback.
17 CLEAR
Press to delete previous selections.
18 DISPLAY
Press to display the tape counter, clock and status
mode on the TV screen.
Accessories
Carefully remove the VCR from the carton. Check that the
VCR has not been damaged. The following accessories
are included.
Overview of the equipment,
continued
1. Wireless Remote Control
NOTE:Required 2 ‘AAA’
batteries.
2. Coaxial cable for
connecting the VCR to
your TV’s VHF terminal.
Daewoo Video Cassette Recorder User’s Guide Daewoo Video Cassette Recorder User’s Guide
To Next Page
Loading...
Need help?
System
Video
Audio
