3. FUNCTIONS OF THE CONTROL PANEL
4
CONTROL PANEL
• Press this switch to turn the power on or off.
• It can be used to choose water temperature to be supplied.
• As the button is pressed, water temperature will be repeated.
COLD → COLD+HOT → HOT
• In case of the single valve model, there is no wash temperature selector function.
• It can be used to adjust amount of water according to the size of the load to be washed.
• As the button is pressed, water level is selected by MID → HIGH → LOW
• It can be used to pre-engage time for wash.
• It is the button for the partial process or the combination of each process (wash, rinse,
spin) (See page 7)
• If you want to change wash time, rinse times, spin time, you must press this button after
selecting each process by the process button. Also, this button can be used to spin only.
(See page 7)
• It can be used to select the full-automatic program.
• As the button is pressed, program will be selected by following order :
FUZZY → FUZZY+SOAK → HEAVY → HEAVY+SOAK → SPEEDY → SUIT(WOOL)
• Operation and temporary stop is repeated as it is pressed.
• When you want to change program in operating;
press the “START/HOLD” button → Select the program that you want to change → press
the “START/HOLD” button again.
RES.
To Next Page
Loading...
Need help?
General
