ANTI-THEFT SYSTEM
The identification card, stamped with the
security code number, is provided with the
vehicle. Keep it in a safe place, not in the
vehicle.
The audio security system activates imme-
diately whenever the audio is disconnected
from the battery. It is protected by a secu-
rity code.
To make the audio system operate again,
you must enter a four-figure security code
with the pre-set station buttons.
The security warning letter "COdE" will be
flashed in the L.C.D when the audio sys-
tem is switched off and disappears when
audio system is switched on.
How to enter the security code
1. When the audio system is reconnec-
ted to the battery, the security warning
letter "COdE" will be flashed in the
L.C.D.
2. Turn the ignition switch to the ON (II)
position and switch on the audio sys-
tem by pushing the power on/off but-
ton.
3. "COdE" will disappear and the initial
setting indicator "- - - -" will appear.
4. Enter a four-figure security code us-
ing the preset station buttons.
5. If the code is correct, the radio FM
mode is switched on after about 2
seconds.(if the cassette tape is inserted
in the slot, the cassette mode is
switched on.)
6. If the code is incorrect, the initial
setting indicator "- - - -" will appear
immediately.
To operate the audio system, the cor-
rect code should be entered.
Repeat, the above procedure from 4 to
6.
6-5
7. If 3 incorrect codes are entered, "Err"
will be flashed in the L.C.D, and the
audio system cannot be operated.
The audio system should be discon-
nected from the battery until "Err" dis-
appears on the L.C.D.
8. When the L.CD has cleared repeat the
above procedure (1 to 8)
To Next Page
Loading...
Need help?
General
