1
PRECAUTIONS TO BE OBSERVED BEFORE AND
DURING SERVICING TO AVOID POSSIBLE
EXPOSURE TO EXCESSIVE MICROWAVE ENERGY
(a)Do not operate or allow the oven to be operated with the door open.
(b)Make the following safety checks on all ovens to be serviced before activating the magnetron or other
microwave source, and make repairs if necessary: (1) Interlock operation, (2) Proper door closing, (3)
Seal and sealing surfaces (arcing, wear, and other damage), (4) Damage to or loosening of hinges and
latches (5) Evidence of dropping or abuse.
(c) Before turning on power to the microwave oven for any service test or inspection within the microwave
generating compartments, check the magnetron, wave guide or transmission line, and cavity for proper
alignment, integrity, and connections.
(d)Any defective or misadjusted components in the interlock, monitor, door seal and microwave
generation and transmission systems shall be repaired, replaced, or adjusted by procedures described
in this manual before the oven is released to the owner.
TABLE OF CONTENTS
1. SAFETY AND PRECAUTIONS ...................................................................................................................................2
2. SPECIFICATION ..........................................................................................................................................................3
3. INSTALLATION ...........................................................................................................................................................4
4. CONTROL PANEL ......................................................................................................................................................5
5. DISPLAY WINDOW .....................................................................................................................................................6
6. ACCESSORIES ...........................................................................................................................................................7
7. INTERLOCK MECHANISM AND ADJUSTMENT ....................................................................................................10
8. WIRING PROCEDURE ..............................................................................................................................................11
9. WIRING DIAGRAM ....................................................................................................................................................12
10. ELECTRICAL PARTS LIST ....................................................................................................................................13
11. DISASSEMBLY AND ASSEMBLY..........................................................................................................................14
12. COMPONENT TEST PROCEDURE .......................................................................................................................27
13. TROUBLE SHOOTING GUIDE ...............................................................................................................................30
14. PRINTED CIRCUIT BOARD ...................................................................................................................................36
To Next Page
Loading...
Need help?
General
