7
Figure 1-3
Please refer to the following sheet for detailed information.
Port Name Connection Function
USB port. Connect to USB mouse.
Network port 10M/100M/1000M self-adaptive Ethernet
port. Connect to the network cable.
RS232 232 debug COM. It is for general COM debug to configure IP
address or transfer transparent COM data.
HDMI High Definition Media
Interface
High definition audio and video signal output
port. It transmits uncompressed high
definition video and multiple-channel data to
the HDMI port of the display device.
VGA
VGA video output port VGA VGA video output port. Output analog video
signal. It can connect to the monitor to view
analog video.
1-16 Alarm input port.
z There are four groups. The first group is
from port 1 to port 4, the second group is
from port 5 to port 8, the third group is
from 9 to 12, and the fourth group is from
13 to 16. They are to receive the on-off
signal from the external alarm source.
There are two types; NO (normal
open)/NC (normal close).
z When your alarm input device is using
external power, please make sure the
device and the NVS have the same
ground.
Alarm input port
ground end
Alarm input ground end.
NO1 to NO3
C1 to C3
3-ch alarm output port
z 3 groups of alarm output ports. (Group 1：
port NO1～C1,Group 2:port NO2～
C2,Group 3:port NO3～C3）).Output
alarm signal to the alarm device. Please
make sure there is power to the external
alarm device.
z NO：Normal open alarm output port.
z C：Alarm output public end.
A RS485_A port. It is the cable A. You can
connect to the control devices such as speed
dome PTZ.
B
RS485 port
I/O port
RS485_B.It is the cable B. You can connect
to the control devices such as speed dome
PTZ.
Power input port Input 12V DC.
Power button Power on/off button.
1.6.2 32-P Series/32-S Series
To Next Page
Loading...
Need help?
General
