User’s Manual
17
Recognition Figure 4-9
Configure recognition area. Step 4
The config example on the right of video image can be used as a reference.
1) Click Iden Area.
Click and draw 4 lines on the video image and the recognition area is formed.
2) Click Snap Line.
Draw snap line via dragging mouse on the area. The snap line must cross the
area.
3) Click Save to complete the settings.
Click Finish, exit guide interface and enter Live interface. Step 5
Lattice Screen 4.4
Lattice screen displays different information when vehicle passes and in normal state. The Kit
also broadcast screen information according to the broadcast content settings.
4.4.1 Lattice Screen Config
You can configure the information displayed on the screen in Car Pass State and Normal
State.
Select Setup > ITC > Lattice Screen Config. Step 1
To Next Page
Loading...
Need help?
General
