User’s Manual
III
Important Safeguards and Warnings
This chapter describes the contents covering proper handling of the Kit, hazard prevention, and
prevention of property damage. Read these contents carefully before using the Kit, comply with
them when using, and keep the manual well for future reference.
Power Requirements
Use the recommended power cables in the region and conform to the rated power
specification.
Use the power adapter provided with the Kit; otherwise, it might result in people injury and
device damage.
The power source shall conform to the requirement of the Safety Extra Low Voltage (SELV)
standard, and supply power with rated voltage which conforms to Limited power Source
requirement according to IEC60950-1. Note that the power supply requirement is subject
to the device label.
Connect the Device (I-type structure) to the power socket with protective earthing.
The appliance coupler is a disconnection device. Keep a convenient angle when using it.
Application Environment Requirements
Do not aim the Kit at strong light (such as lamplight, sunlight) for focusing.
Transport, use and store the Kit under the allowed humidity and temperature conditions.
Prevent any liquid from flowing into the Kit.
Do not block the ventilation opening near the Kit.
Do not press, vibrate or soak the Kit during transportation, storage and installation.
Pack the Kit with packaging materials provided by its manufacturer or materials with the
same quality before transporting it.
Ground the Kit to improve its reliability.
Operation and Maintenance Requirements
Do not dissemble the Kit.
Clean the surface of access ANPR camera with a soft dry cloth or a clean soft cloth dipped
in neutral detergent, and then dry the surface.
Use accessories suggested by the manufacturer, and install and maintain the Kit by
professional personnel.
Do not provide two or more than two kinds of power supply modes; otherwise, the Kit may
be damaged.
For support tools, contact the technical support.
To Next Page
Loading...
Need help?
General
