User’s Manual
20
Click Remove All to delete all the broadcast items.
Click Confirm. Step 6
4.4.3 Volume/Code Set
You can configure the input volume, and the volume and speed of speaker.
Select Setting > ITC > Voice Broadcast > Volume/Code Set. Step 1
Volume/Code set Figure 4-14
Configure the parameters. Step 2
It is recommended to click Default and then Confirm to use default configurations.
Volume Input: The volume of user who wants to park vehicle.
Output Volume: The volume of voice broadcast.
Speaker Speed: The speed of voice broadcast.
Click Confirm. Step 3
Config (LPR) 4.5
This section is only applicable to the Camera.
Open browser, enter IP address of the Camera in the address bar, and then press Step 1
Enter.
The web login interface is displayed.
Enter the username and password, and then click Login.
Step 2
The main page of web interface is displayed.
The IP address is 192.168.1.108 by default. The IP address shall be modified when
login for the first time. To modify the IP address, see "4.1 Initializing Camera."
To Next Page
Loading...
Need help?
General
