5 Basic Function Introduction
5.1 Call Function
5.1.1 Call Resident
Press Call button under standby status, and the VTO will call user. User may monitor VTO
from VTH.
On VTH, press Unlock button to unlock door.
When VTH picks up, you can start talk with the VTH.
If no one answers the call, then the call will end automatically and device returns to
standby status.
5.1.2 Group Call
Group call is mainly used for one VTO. Press Call button on VTO to call multiple VTH at
the same time. A resident can answer, hang up and unlock on any one unit of VTH.
VTH consists of master VTH and extension VTH. A system can only have a max of 1
master VTH and 3 extension VTHs.
Set VTO
Step 1. Select System Config>Indoor Manager.
Step 2. Click in Indoor Manager interface to delete default VTH9901.
Step 3. Click Add, input VTH short no., input IP address (optional) to add one VTH.
Note:
In Indoor Manager interface, only need to add main VTH.
See Figure 5- 1.
To Next Page
Loading...
Need help?
General
